Automatic Technology Australia Elite Provozní pokyny stáhnout pdf (Strana 7)

(ATA Order code 90182)

FIG. 8

INSTALLATION OF MINIMUM SIDE ROOM KIT

If you have limited Side Room, a special kit allows you to modify the Elite Swing Gate Opener so that the space required is reduced

to the width of the Drive Unit (135mm). (ATA Order code 90182).

NOTE: If a shorter Arm is required, drill the Drive Arm Exten-

sion and Extension Arm where appropriate, you should not have

to cut the arms and should still be able to use pre-threaded hole in

Drive Arm Extension.

WARNING

KEEP HANDS AND ANY LOOSE CLOTHING WELL

CLEAR OF THE GATE(S) AND GATE OPERATOR AT

ALL TIMES. SERIOUS PERSONAL INJURY AND/OR

PROPERTY DAMAGE CAN RESULT FROM FAILURE

TO FOLLOW THIS WARNING

Page. 7

FITTING MINIMUM SIDE ROOM KIT

STEP 3A

1. Secure the Extension Arm from the minimum side room kit

onto Drive Arm Extension with supplied M12 screws. Drill

Ø12 hole in Drive Arm Extension (use hole in extension arm

as a guide). Insert other M12 screw and secure with spring

washer and nut. Check that screws are tight (Fig 8).

2. Check the Drive Unit is DISENGAGED AND THE GATE

IS CLOSED (Fig 4). Slide the Guide Track over idler. Locate

Track on gate and check travel of the Arm. The idler should

always be inside the Guide Track in the closed and open posi-

tions. Secure (weld) track to gate (Fig 7 & 8).

FIG. 7

FIG. 5

INSTALLATION OF MECHANICAL DRIVE UNIT

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Žádné komentáře

Automatic Technology Australia Elite Provozní pokyny Strana 7